Hyundai Kona Quiz
Body Electrical System

Power Mirror Switch Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

[Power Window Switch]
  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver door trim panel. (Refer to Body - "Front Door Trim Panel")
  3. Disconnect the power mirror switch connector from the door trim.
  4. Check for continuity between the terminals at each switch position. Refer to the [Power Mirror Switch] table.
    [Power Mirror Switch]

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  3. Remove the power window unit (A).

Installation

  1. Install the power window switch assembly.
  2. Install the front door trim panel after connecting the connector.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.