Hyundai Kona Quiz
Body (Interior and Exterior)

Rear Bumper Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
8steps
~48min
3/5difficulty
Done 0 of 8

Replacement

  1. Loosen the mounting bolts and remove the rear combination lamp (A).
  2. Disconnect the rear combination lamp connector (A).
  3. Loosen the mounting bolts (A).
  4. Loosen the mounting clip and remove the rear part of the lower cover (A).
  5. After loosening the lock pins and side screws, disconnect the side of the rear bumper (A).
  6. Loosen the mounting screws and clips, then remove the rear bumper cover (A).
  7. Disconnect the rear bumper main connector (A).
  8. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.