Hyundai Kona Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
16steps
~96min
4/5difficulty
Done 0 of 16

Inspection

Front Door Lock Module Inspection
  1. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  2. Remove the front door module. (Refer to Body - "Front Door Module")
  3. Disconnect the actuator connector.
    No Terminal Information
    left Right Side
    1 AJAR switch -
    2 Lock/Unlock Switch COM motor
    3 COM CL motor
    4 Key unlock switch Key interlock switch
    5 Key interlock switch Key unlock switch
    6 CL motor COM
    7 COM motor Lock/Unlock Switch
    8 - AJAR switch
  4. Check actuator operation by connecting power and ground according to the table. To prevent actuator damage, apply battery voltage only momentarily.
  5. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  6. Remove the rear door module. (Refer to Body - "Rear Door Module")
  7. Disconnect the actuator connectors.
    No Terminal Information
    left Right Side
    1 AJAR switch -
    2 Lock/Unlock Switch COM motor
    3 COM CL motor
    4 - -
    5 - -
    6 CL motor COM
    7 COM motor Lock/Unlock Switch
    8 - AJAR switch
  8. Check actuator operation by connecting power and ground according to the table. To prevent actuator damage, apply battery voltage only momentarily.
  9. Remove the trunk lid trim. (Refer to Body - "Trunk Lid Trim")
  10. Disconnect the actuator connector.
  11. Check actuator operation by connecting power and ground according to the table. To prevent actuator damage, apply battery voltage only momentarily.
  12. Check the trunk power supply of the variant, refer to the main body module.
  13. Disconnect the connector (A).
  14. Check circuit continuity between the terminals and ground according to the table (Refer to Body - Hood Latch).
  15. Remove the siren (A) after loosening the mounting bolts and disconnect the connector (B).
  16. Check the security siren by connecting the battery to terminal 2 and grounding terminal 1.
Rear Door Lock Module Inspection / Hood Switch Inspection / Intrusion Sensor Horn Inspection

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.