Hyundai Kona Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
14steps
~84min
3/5difficulty
Done 0 of 14

Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the lower driver airbag panel. (Refer to Body - "Driver Airbag Module")
  3. Remove the upper and lower steering column covers.
  4. Turn the key to the ACC position.
  5. Disconnect the connector (A) and remove the lock cylinder (C) after pressing the stopper pin (B).
  6. Loosen the mounting bolts and remove the ignition lock (B).

Inspection

  1. Disconnect the ignition switch connector (A) and the key warning/immobilizer connector (B) from under the steering column.
  2. Check the circuit between the terminals for continuity.
  3. If continuity is not as specified, replace the switch.

Installation

  1. Install the key cylinder lock.
  2. Install the key warning switch and the immobilizer connector.
  3. Install the ignition lock.
  4. Install the steering column covers and the lower airbag panel.
  5. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.