Body (Interior and Exterior)
Troubleshooting
In this manual: Body (Interior and Exterior)
~1min read
Troubleshooting
| Symptom | Passive Cause | Remedy (Refer to page) |
| Water Leaking from Sunroof | Worn Roof Cover Seal | Replace |
| Excessive gap between the roof panel and the body, and incorrectly installed weatherstrip | Adjust | |
| Wind noise around the sunroof | Loose or deformed deflector, body gaps | Tighten, adjust or replace |
| Noise from the moving sunroof | Foreign material caught in the guide rail | Check the drive cable and guide rails for foreign material. |
| Loose guide rails and sunroof panel | Tighten | |
| Motor runs but sunroof does not move or moves partially | Foreign material caught in the guide rail | Adjust or replace |
| Motor pinion gear incorrectly engaged with drive cable | ||
| Reduced Sunroof Slip Force | ||
| Increased sliding resistance of the sunroof or interference with the drive cable, seal, etc. due to incorrect sunroof adjustment | ||
| Motor noise (sunroof motor clutch slip noise when the sunroof is fully open or closed) is considered normal | Motor pinion gear incorrectly engaged with drive cable | Check the gear installation and tighten the motor. |
| Worn or damaged motor pinion gear bearing | Replace the motor assembly | |
| Worn or deformed drive cable | Replace | |
| Door glass does not move up or down | Incorrectly installed window glass | Adjust the position |
| Damaged or faulty regulator arm or regulator | Repair or replace | |
| Door does not open or close fully | Incorrectly installed door | Adjust the position |
| Faulty door lock assembly | Repair or replace | |
| Door hinge requires lubrication | Apply grease | |
| Hood does not open or close fully | Striker and latch are not properly aligned | Adjust |
| Incorrectly installed hood seal | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leaks through the windshield and rear window | Defective seal | Apply sealant |
| Defective flange | Correct |
Test yourself
A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?