Body Electrical System

Power Door Lock Module

12steps
~72min
3/5difficulty
Done 0 of 12

Components and Component Location

COMPONENTS

1. Door Lock/Unlock Handle Cable
2. Inside Handle Conductive Cable
3. Door Latch

Repair Procedures

Inspection

Front Door Lock Module Inspection
  1. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  2. Remove the front door module. (Refer to Body - "Front Door Module")
  3. Disconnect the actuator connector.
    NO Spindle Information
    LEFT LAW
    1 Tilt Switch -
    2 Lock/Unlock Switch Motor 1
    3 COM Motor 2
    4 INSIDE DOOR LOCK Key Switch
    5 Key Switch INSIDE DOOR LOCK
    6 Motor 2 COM
    7 Motor 1 Lock/Unlock Switch
    8 - Tilt Switch
  4. Check the actuator operation by applying power and ground as shown below. To avoid damaging the actuator, apply battery voltage only temporarily.
  5. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  6. Remove the rear door module. (Refer to Body - "Rear Door Module")
  7. Disconnect the actuator connector.
    NO Spindle Information
    LEFT LAW
    1 Tilt Switch -
    2 Lock/Unlock Switch Motor 1
    3 COM Motor 2
    4 - -
    5 - -
    6 Motor 2 COM
    7 Motor 1 Lock/Unlock Switch
    8 - Tilt Switch
  8. Check the actuator operation by applying power and ground as shown below. To avoid damaging the actuator, apply battery voltage only temporarily.
  9. Remove the trunk lid trim. (Refer to Body - "Trunk Lid Trim")
  10. Disconnect the switch connector.
  11. Check the actuator operation by applying power and ground as shown below. To avoid damaging the actuator, apply battery voltage only temporarily.
  12. Check the electrical options of the rear door via the rear door module.
Inspection of Tailgate Lock Module

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.