Brake Line Repair Procedures

Removal

1. 1
   Disconnect the brake fluid level switch connector and remove the reservoir cap.
2. 2
   Remove the brake fluid from the master cylinder reservoir using a syringe.

   Do not spill brake fluid on the vehicle, as it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.

3. 3
   Remove the wheel and tire.
4. 4
   Remove the brake hose clamp (A). [Front]

   

   [Rear]

   

5. 5
   Disconnect the brake tube by loosening the tube flare nut (B).

   Tightening torque: 12.7 - 16.7 N·m

6. 6
   Disconnect the brake hose from the brake caliper by loosening the bolt (C).

   Tightening torque: 24.5 - 29 N·m

   [Front]

   

   [Rear]

   

Inspection

1. 1
   Inspect the brake tubes for cracks, bends and corrosion.
2. 2
   Inspect the brake hoses for cracks, damage and fluid leaks.
3. 3
   Inspect the tube flare nuts for damage and fluid leaks.
4. 4
   Inspect the brake hose mounting bracket for cracks or deformation.

Installation

1. 1
   Installation is the reverse of removal.

   Use a new gasket (A) when installing.

   

2. 2
   After installation, bleed the brake system. (Refer to Brake System Bleeding)
3. 3
   Inspect for spilled brake fluid.