Wheel Repair Procedures

Hub Nut Tightening Sequence

Tighten the wheel nuts as follows. Tightening torque (front): 88.25 ~ 108 N·m Tightening torque (rear): 88.3 ~ 108 N·m

When using an impact wrench, the final tightening torque must be checked with a torque wrench.

Perform inspection

1. 1
   Raise the vehicle.
2. 2
   Measure wheel runout with a dial indicator as shown in the illustration below.

   Run out	Aluminum	Steel
   Radial mm (in)	Less than 0.3 (0.012)	Less than 1.0 (0.039)
   Axial mm (in)	Less than 0.3 (0.012)	Less than 0.6 (0.024)

3. 3
   If the measured value exceeds the specified value, replace the wheel.