Hub Bearing Installation

• Before installing the hub bearings, blow any dirt or foreign particles out of the hub with compressed air to prevent contamination of the bearings.
• Replace the bearings with new ones.
• Install the bearings by using the bearing driver set which does not contact the bearing inner race.

NOTE

Install the bearings so that the marked side faces out.

• Press in each right the bearing [A] until they are bottomed.

Special Tool - Bearing Driver Set [B]: 57001-1129

• Replace the grease seals with new ones.
• Press in the grease seals [A] so that the seal surface is flush [B] with the end of the hole.

Apply high-temperature grease to the grease seal lips.

Special Tool - Bearing Driver Set [C]: 57001-1129