Kawasaki Ninja ZX-10R Quiz
Clutch

Release Shaft Installation

In this manual: Clutch
General Information — 26Periodic Maintenance — 66Fuel System (DFI) — 79Cooling System — 28Engine Top End — 51Clutch — 24Engine Lubrication System — 28Engine Removal/Installation — 5Crankshaft/Transmission — 65Wheels/Tires — 22Final Drive — 17Brakes — 54Suspension — 36Steering — 17Frame — 40Electrical System — 104Self-Diagnosis System — 112Appendix — 10
~1min read
  • Apply grease to the oil seal lips on the upper ridge of the clutch cover.
  • Apply engine oil to the needle bearings in the hole of the clutch cover.
  • Applymolybdenum disulfide grease to the pusher-holding portion [A] on the release shaft.
  • Install the washer [B] and spring [C].
Release Shaft Installation

  • Insert the release shaft straight into the upper hole of the clutch cover.

NOTICE

When inserting the release shaft, be careful not to remove the spring of the oil seal.

  • Fit the spring [A] as shown in the figure.
Release Shaft Installation

Test yourself

A quick Kawasaki Ninja ZX-10R quiz: every answer comes with an explanation and a link to the manual page.