Kawasaki Ninja ZX-10R Quiz
Engine Top End

Throttle Body Assy Holder Installation

In this manual: Engine Top End
General Information — 26Periodic Maintenance — 66Fuel System (DFI) — 79Cooling System — 28Engine Top End — 51Clutch — 24Engine Lubrication System — 28Engine Removal/Installation — 5Crankshaft/Transmission — 65Wheels/Tires — 22Final Drive — 17Brakes — 54Suspension — 36Steering — 17Frame — 40Electrical System — 104Self-Diagnosis System — 112Appendix — 10
~1min read
  • Be sure to install the new O-rings [A].
  • Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth.
  • Apply silicone sealant to any two positions of the new O -ring.

Sealant - Liquid Gasket, TB1211F: 92104-0004

  • Install the holders [B] as shown in the figure.
Recession [C]
  • Tighten the holder bolts [D] as shown sequence [1 ∼ 3] in the figure.

    • Torque - Throttle Body Assy Holder Bolts: 9.8 NВ·m (1.0 kgfВ·m, 87 inВ·lb)

    Throttle Body Assy Holder Installation

    Test yourself

    A quick Kawasaki Ninja ZX-10R quiz: every answer comes with an explanation and a link to the manual page.