Troubleshooting

Troubleshooting

Symptom Table

Before replacing or repairing air conditioning components, first determine whether the malfunction is related to refrigerant charge, airflow, or the compressor. Use the table below to find the cause of the problem. The numbers indicate the priority of the probable cause. Check each part in order. If necessary, replace these parts. After troubleshooting, check the entire system to make sure it is operating properly. Standard:

Symptom	Suspected Area
No Fan Operation	1. Blower Fuse
	2. Blower Relay
	3. Blower Motor
	4. Power MOSFET
	5. Blower Speed Switch
	6. Wiring Harness
No Air Temperature Control	1. Engine Coolant Reservoir
	2. Heater Control Unit
Compressor Does Not Operate	1. Cooling Capacity
	2. A/C Fuse
	3. Clutch Stopper
	4. Compressor
	5. A/C Pressure Sensor
	6. A/C Switch
	7. Evaporator Temperature Sensor
	8. Wiring Harness
Vent Air Not Cold	1. Cooling Capacity
	2. Refrigerant Pressure
	3. Drive Belt
	4. Clutch Stopper
	5. Compressor
	6. A/C Pressure Sensor
	7. Evaporator Temperature Sensor
	8. A/C Switch
	9. Heater Control Unit
	10. Wire Harness
Insufficient Cooling	1. Cooling Capacity
	2. Drive Belt
	3. Clutch Stopper
	4. Compressor
	5. Condenser
	6. Expansion Valve
	7. Evaporator
	8. Refrigerant Lines
	9. A/C Pressure Sensor
	10. Heater Control Unit
Engine Does Not Idle Well with A/C On	1. Engine ECM
	2. Wiring Harness
No Air Flow Control	1. Heater Control Unit
No Mode Control	1. Heater Control Unit
	2. Mode Actuator
Cooling Fan Does Not Operate	1. Cooling Fan Fuse
	2. Blower Motor
	3. Engine ECM
	4. Wiring Harness