Maintenance

Headlamp aiming (for Europe). Aiming point

12steps
~72min
3/5difficulty
Done 0 of 12
European specification headlamp aiming setup and alignment guide diagram for the Kia EV2

NOTE

  • Inflate the tyres to the specified pressure and remove any loads from the vehicle except the driver, spare tyre, and tools.

  • The vehicle should be placed on a perfectly flat floor surface to ensure accurate calibration.

  • Draw vertical lines (Vertical lines passing through respective head lamp centers) and a horizontal line (Horizontal line passing through centre of head lamps) on the aiming screen.

  • With the head lamp and battery in normal operating condition, aim the head lamps so the brightest portion falls precisely on the intersection of horizontal and vertical lines.

  • To aim the low beam left or right, turn the adjustment screwdriver (1) clockwise or counterclockwise. To aim the low beam up or down, turn the adjustment screwdriver (2) clockwise or counterclockwise.

Aiming point

Technical dimensional layout for the left-hand drive Kia EV2 low beam headlamp aiming pattern
Detailed adjustment point reference illustration for the Kia EV2 low beam headlamp module
  1. Screen

Vehicle condition

Head lamp (LED type)

Ground Height

Distance between lamps

H1 (LOW)

H2 (HIGH)

W1 (LOW)

Head lamp

Without driver

[mm (inches)]

836

(32.9)

704

(27.7)

1,467

(57.8)

With driver

[mm (inches)]

830

(32.7)

698

(27.5)

Head lamp low beam (LHD Vehicle)

Figure 1. Based on 10 m screen
Engineering projection screen schematic for left-hand drive Kia EV2 low beam cut-off line calibration
  1. Vehicle axis

  2. Vehicle line of the left head lamp bulb centre

  3. Vehicle line of the right head lamp bulb centre

  4. Horizontal line of the head lamp bulb centre

  5. Cut-off line

  6. Ground

  • Turn the low beam on without driver aboard.

  • The cut-off line should be projected in the exact position shown in the reference picture.

  • When aiming the low beam, vertical aiming should always be adjusted after completing the horizontal adjustment.

  • Disengage the parking brake and shift to N (Neutral). In addition, if a headlamp levelling device is equipped, adjust the headlamp levelling device switch to 0.

Head lamp low beam (RHD Vehicle)

Figure 2. Based on 10 m screen
Engineering projection screen schematic for right-hand drive Kia EV2 low beam cut-off line calibration
  1. Vehicle axis

  2. Vehicle line of the left head lamp bulb centre

  3. Vehicle line of the right head lamp bulb centre

  4. Horizontal line of the head lamp bulb centre

  5. Cut-off line

  6. Ground

  • Turn the low beam on without driver aboard.

  • The cut-off line should be projected in the exact position shown in the reference picture.

  • When aiming the low beam, vertical aiming should always be adjusted after completing the horizontal adjustment.

  • Disengage the parking brake and shift to N (Neutral). In addition, if a headlamp levelling device is equipped, adjust the headlamp levelling device switch to 0.