Seating and safety restraints

Securing a Child Restraint System with a lap/shoulder belt

4steps
~24min
2/5difficulty
Done 0 of 4

When not using the ISOFIX system, all Child Restraint Systems must be properly secured to a rear seat of your Kia EV2 using the lap portion of a lap/shoulder belt.

Kia EV2 rear passenger seat showing the correct routing of a lap and shoulder belt through a child safety restraint

To successfully install a Child Restraint System on the rear seats of your Kia EV2, carefully execute the following systematic steps:

  1. Place the Child Restraint System firmly on a designated rear seat and route the vehicle lap/shoulder belt around or directly through the Child Restraint System, strictly following the specific installation guidelines provided by the Child Restraint System manufacturer.

    Make sure that the seat belt webbing remains completely flat and is never twisted at any point.

  2. Fasten the lap/shoulder belt metal latch securely into the seat buckle, listening closely for the distinct, audible "click" sound that confirms proper engagement. Position the release button carefully so that it remains easily accessible at all times in case of an emergency evacuation.

  3. Remove as much excess slack from the belt system as possible by firmly pushing down on the base of the Child Restraint System while simultaneously feeding the excess shoulder belt webbing back into the emergency locking retractor.

  4. Thoroughly push and pull on the Child Restraint System from multiple angles to confirm that the seat belt is holding it rigidly and firmly in place against the vehicle seat.

If the manufacturer of your Child Restraint System recommends utilizing an ISOFIX top tether strap in combination with the standard lap/shoulder belt, please refer to the dedicated section covering the securing of a child seat with the “ISOFIX top tether anchorage” system later in this chapter.

To remove the Child Restraint System from your Kia EV2, simply press the red release button on the buckle, carefully pull the lap/shoulder belt out from the routing paths of the Child Restraint System, and allow the vehicle seat belt mechanism to retract fully.