Engine Electrical System

Troubleshooting

~2min read

Trouble Shooting

Ignition System

Symptom Suspect area Remedy
Vehicle indicates Ready in dash, but engine will not run when requested by the HPCU (HEV module). Ignition coil Inspect ignition coil, or replace as required
Spark plugs Inspect spark plugs, or replace as required
Ignition wiring disconnected or broken Repair wiring, or replace as required
Rough idle Ignition wiring Repair wiring, or replace as required
Ignition coil Inspect ignition coil, or replace as required
Engine hesitates/poor acceleration Spark plugs and spark plug cables Inspect spark plugs / cable, or replace as required
Ignition wiring Repair wiring, or replace as required
Poor mileage Spark plugs and spark plug cables Inspect spark plugs / cable, or replace as required

Charging System

Symptom Suspect area Remedy
Charging warning indicator does not light with Start/Stop Button "ON" and Hybrid System off. Fuse blown Check fuses
Light burned out Replace light
Wiring connection loose Tighten loose connection
LDC problem Check the LDC.
Refer to HC group
Charging warning indicator does not go out with Hybrid System on. (Battery requires frequent recharging) Battery cable loose, corroded or worn Inspect cable connection, repair or replace cable
LDC problem Check the LDC.
Refer to HC group
Wiring Repair or replace wiring
Overcharge LDC problem Check the LDC.
Refer to HC group
Voltage sensing wire Repair or replace wiring
Discharge Wiring connection loose or short circuit Inspect wiring connection, repair or replace wiring
LDC problem Check the LDC.
Refer to HC group
Poor grounding Inspect ground or repair
Worn battery Replace battery
Abnormal parasitic draw from the vehicle Install a current probe to measure current. It should be less than 0.05A (50mA) after Hybrid System off and waiting 10 minutes. Make sure trunk light is removed for this test.

Starting System

Symptom Suspect area Remedy
Vehicle will not indicate Ready in dash at Hybrid System on. Auxiliary 12V battery charge low Charge or replace auxiliary 12V battery
Auxiliary 12V battery cables loose, corroded or worn out Repair or replace cables
Transaxle range switch (Vehicle with automatic transaxle only) Refer to AT group-automatic transaxle
Fuse blown Replace fuse
Ignition switch faulty Replace