Kia Sorento XM 2011-2023 Repair Manual
Sunroof Motor Inspection
In this manual: Kia Sorento XM 2011-2023 Repair Manual
13steps
~78min
3/5difficulty
Done 0 of 13
- Fully close the sunroof glass and sunshade (fully closed position).
- Disconnect the negative (-) battery terminal.
- Remove the roof headliner assembly. (Refer to Body - "Roof Trim")
- Remove the sunroof motor (A) after loosening the screws and disconnecting the connector.

- Check the sunroof motor wiring connector as shown in the table below.
Terminal Test Conditions Test: Expected Result 3 - Ground IG2 ON Check the voltage to ground:
There should be battery voltage1 - Ground Under any condition Check continuity to ground:
Continuity should be present.6 - Ground Under any condition Check voltage to ground:
Battery voltage should be present. - Remove the sunshade motor (A) after loosening the screws and disconnecting the connector.

- Check the sunshade motor wiring connector as shown in the table below.
Terminal Test Conditions Test: Expected Result 1 - Ground Under any condition Check continuity to ground:
Continuity should be present.6 - Ground Under any condition Check voltage to ground:
Battery voltage should be present. - Connect the sunroof glass and sunshade motor, and all connectors.
- Connect the negative (-) battery terminal.
- Start the vehicle engine.
- Check the motor operation by pressing the sunroof switch.
Terminal Operation Test Auto Open
SwitchGlass and sunshade motors operate Auto Close
SwitchGlass and sunshade motors operate Auto Tilt Up
SwitchGlass and sunshade motors operate Sunshade Open
SwitchSunshade motor operates Sunshade Close
SwitchSunshade motor operates - After checking the motor operation, turn on the auto close switch.
- Install the sunroof glass motor and sunshade motor. Then perform the sunroof reset procedure.
Test yourself
A quick Kia Sorento Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?