Rear Wiper Motor Repair Procedures

Inspection

1. 1
   Disconnect the 4-pin connector from the rear wiper motor.
2. 2
   Connect the positive (+) and negative (-) battery cables to terminals 3 and 4, respectively.
3. 3
   Check that the motor operates normally. Replace the motor if it operates abnormally.

   No.	Description
   1	Battery (+)
   2	Parking
   3	Wiper Motor Input (+)
   4	Ground

   
   

   

4. 4
   Operate the motor at low speed using the wiper switch on the steering column.
5. 5
   Stop the motor at any position other than OFF by disconnecting terminal 3.
6. 6
   Connect terminals 2 and 3.
7. 7
   Connect the positive (+) battery cable to terminal 1, and the negative (-) cable to terminal 4.
8. 8
   Check that the motor stops in the OFF position.

   

Removal

1. 1
   Remove the rear wiper cover (A).

   

2. 2
   Remove the rear wiper arm and blade (A) after removing the rear wiper nut (B).

   

3. 3
   Open the tailgate, then remove the tailgate trim. (Refer to Body - Tailgate Trim)
4. 4
   Disconnect the rear wiper motor connector (C), then remove the rear wiper motor (A) after loosening the bolts (3EA).

   

Installation

1. 1
   Install the rear wiper motor assembly and grommet.

   Bolt Tightening Torque: 6.9~9.8 N·m

2. 2
   Install the liftgate trim.
3. 3
   Install the rear wiper blade and align it with the lowest line of the rear window defroster and the rear glass.

   

4. 4
   Install the rear wiper cover and the rear wiper nut.

   Nut Tightening Torque: 3.9~6.9 N·m