Repair Procedures

Removal

1. 1
   Remove the front pillar garnish. (Refer to Interior Trim - "Front Pillar Trim")
2. 2
   Loosen the nuts securing the triangular fixed glass (A).

   Tightening torque: 3.9 ~ 4.4 N·m

   

3. 3
   Cut the sealant using the sealant cutting tool [A(09861-31000)].

   • Remove the grommet and clips from the body.
   • Mask the surrounding surfaces before painting.
4. 4
   Remove the triangular fixed glass.

Installation

1. 1
   Using a scraper, scrape off the old adhesive to a thickness of approximately 2 mm (0.08 in.) on the bonding surface around the entire delta fixed glass flange.
2. 2
   Clean the body bonding surface with a sponge dampened with alcohol. After cleaning, make sure oil, grease, and water do not contact the surface.
3. 3
   Using a sponge, apply a thin coat of glass primer along the edge of the triangular window glass as shown in the illustration, then lightly wipe it with gauze or cloth:
4. 4
   Using a sponge, apply a thin coat of body primer to the original adhesive remaining around the flange. Allow the body primer to dry for at least 10 minutes.
5. 5
   Load the adhesive into the cartridge without air pockets to ensure continuous flow. Place the cartridge in the sealant gun and apply a bead of sealant around the edge of the triangular fixed glass (A), as shown in the illustration. Apply the adhesive within 30 minutes after applying the glass primer. Make the bead slightly thicker at each corner.

   

6. 6
   Install the triangular fixed glass.
7. 7
   Allow the adhesive to cure for at least one hour, then spray water onto the triangular fixed glass and check for leaks. Mark any leak points, allow the triangular fixed glass to dry, then seal with sealant. Allow the vehicle to stand for at least four hours after installing the triangular fixed glass. If the vehicle must be driven within the first four hours, drive it slowly.
8. 8
   Install all remaining removed parts.
9. 9
   Install the front pillar garnish.