Mazda 3 Quiz
Brakes

DSC Sensor Initialization Procedure

In this manual: Brakes
Vehicle general — 15Accessories — 111Body — 339Brakes — 71Drivetrain — 143Electrical — 58Engine — 251HVAC — 72Restraints — 15Steering — 32Suspension — 41
~1min read
WARNING:

  • If the DSC sensor initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the DSC sensor initialization procedure to insure proper DSC operation.

1. Inspect the wheel alignment and the tire pressure.

  • If there is any malfunction, adjust the applicable part.

2. Position the vehicle on level ground.

3. Switch the ignition to off.

4. Connect the M-MDS (IDS) to DLC-2.


5. After the vehicle is identified, select the following items from the initial screen of the IDS.

  • Select “Chassis”.

  • Select “ABS/DSC”.

  • Select “Sensor Initialization”.

6. Perform the procedure according to the directions on the screen.

7. Drive the vehicle.

8. After 5 min or more

of driving, verify that the DSC system is normal.

Test yourself

A quick Mazda 3 quiz: every answer comes with an explanation and a link to the manual page.