Front Door Module Panel Removal/Installation

1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}

.

2. Disconnect the negative battery cable..

3. Remove the following parts:

a. Inner garnish.

b. Front door trim.

c. Front door speaker.

d. Front door glass.

4. Disconnect the front door wiring harness connector.

5. Remove the clips securing the front door wiring harness from the front door module panel.

CAUTION:

• If the front door wiring harness is placed on the floor after removing the front door wiring harness from the front door module panel, it could be damaged by the front door closing or stepped on while moving. Connect the connector shown in the figure after removing the front door wiring harness and do not place the front door wiring harness on the floor.

6. Remove the bolts.

7. Remove the fastener.

8. Remove the front door module panel.

9. Remove the front power window motor..

10. Remove the front power window regulator..

11. Install in the reverse order of removal.