Mazda 6 Quiz
Heater and air conditioner systems

A/c compressor removal/installation

In this manual: Heater and air conditioner systems
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Disconnect the negative battery cable.

2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)

3. Remove the right side splash shield and mudguard (L.H.D. only).

4. Loosen the drive belt and remove it.

Caution
  • If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

5. Remove in the order indicated in the table. Do not allow compressor oil to spill.



6. Install in the reverse order of removal.

7. Adjust the drive belt.

8. Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST.)

A/C Compressor Installation Note

Remove the following amount of compressor oil from the new A/C compressor when replacing the A/C compressor.

Compressor oil to be removed (approximate quantity) 120 ml {120 cc, 4.06 fl oz} - [compressor oil from old A/C compressor + 15 ml {15 cc, 0.5 fl oz}]

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.