Mazda 6 Quiz
Body electrical system

Cigarette lighter removal/installation

In this manual: Body electrical system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Socket Removal Note

1. Insert a tape-wrapped screwdriver into the socket hole, then press against the ring protrusion to lift the socket toward you.


2. As shown in the figure, lift out the socket until the ring protrusion locks into the lower socket hole.


3. Remove the boot panel.

4. From behind the boot panel, slide a tape-wrapped screwdriver in between the socket and the ring protrusion.


5. While twisting the ring protrusion with the screwdriver, push out and remove the socket.

Ring Removal Note

Pull the ring forward while compressing the hooks.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.