Mazda 6 Quiz
General information

Reassembly

In this manual: General information
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
  • Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.

  • If removed, these parts should be replaced with new ones:

- Oil seals

- Gaskets

- O-rings

- Lockwashers

- Cotter pins

- Nylon nuts

  • Depending on location:

- Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.

- Oil should be applied to the moving components of parts.

- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.