Mazda 6 Quiz
Front and rear axles

Wheel hub, hub spindle removal/installation

In this manual: Front and rear axles
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
Caution
  • Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (body side) and fix it to an appropriate place where the sensor will not be pulled by mistake while the vehicle is being serviced.

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.



Locknut Removal Note

1. Knock the crimped portion of the locknut outward using a small cape chisel and a hammer.


2. Lock the hub by applying the brakes.

3. Remove the locknut.

ABS Sensor Rotor Removal Note Note
  • The sensor rotor does not need to be removed unless it is being replaced.

Remove the sensor rotor using a chisel.


ABS Sensor Rotor Installation Note Caution
  • Position the SST so that marking B faces the bottom.
1. Set the SST

as shown in the figure.


2. Press on the new sensor rotor using the SST

and a press.


Locknut Installation Note

Install a new locknut and stake it as shown.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.