Starting and driving
Fuel Efficient Driving Tips
In this manual: Starting and driving
~3min read
Use the following practical Fuel Efficient Driving Tips to help maximize fuel economy and reduce unnecessary fuel consumption in your Mitsubishi Outlander.
1. Use smooth accelerator and brake pedal application.
- Avoid rapid acceleration and sudden stops whenever traffic conditions allow.
- Apply the accelerator and brake pedals smoothly and progressively to reduce unnecessary changes in vehicle speed.
- Maintain a steady cruising speed during normal driving and coast safely when conditions permit.
2. Maintain constant speed.
- Look well ahead and anticipate changing traffic conditions to reduce unnecessary stops.
- Adjusting vehicle speed to the timing of traffic signals can help reduce repeated stopping and acceleration.
- Maintaining a steady speed where possible can reduce red-light stops and improve overall fuel efficiency.
3. Use climate control at higher vehicle speeds.
- Below 64 km/h, opening the windows may be more efficient for cooling the passenger compartment because it can reduce engine load from air-conditioning operation.
- Above 64 km/h, using the A/C may be more efficient than driving with the windows open because open windows can increase aerodynamic drag.
- When the A/C is operating, recirculating already-cooled cabin air can reduce the cooling load and help the system operate more efficiently.
4. Drive at economical speeds and distances.
- Observing posted speed limits and, where legally permitted, avoiding speeds above 97 km/h can improve fuel economy by reducing aerodynamic drag.
- Maintain a safe following distance from the vehicle ahead to reduce unnecessary braking and repeated acceleration.
- Monitor traffic conditions well ahead so changes in traffic speed can be anticipated, allowing smoother braking and acceleration.
- Select a gear range appropriate for current road and driving conditions.
5. Use cruise control.
- Using cruise control during suitable highway driving can help the Mitsubishi Outlander maintain a more consistent speed.
- Cruise control can be particularly effective for reducing unnecessary speed variation and improving fuel economy on relatively flat roads.
6. Plan for the shortest route.
- Use a map or navigation system to select an efficient route that can reduce travel distance, unnecessary delays, and driving time.
7. Avoid idling.
- When it is safe and appropriate to do so, shutting off the engine during stops lasting longer than approximately 30-60 seconds can save fuel and reduce emissions.
8. Buy an automated pass for toll roads.
- Automated toll passes can allow drivers to use designated lanes and maintain a more consistent speed through toll areas instead of repeatedly stopping and accelerating.
9. Winter warm up.
- Keep engine idling time as short as practical to minimize unnecessary fuel consumption.
- Under typical conditions, the vehicle generally requires no more than approximately 30 seconds of idling after startup to begin circulating engine oil effectively before driving.
- The Mitsubishi Outlander normally reaches its ideal operating temperature more quickly while being driven than while remaining stationary at idle.
10. Keeping your vehicle cool.
- Whenever possible, park the vehicle in a covered parking area or shaded location to reduce heat buildup inside the cabin.
- When entering a hot vehicle, opening the windows briefly can help release trapped heat and lower the interior temperature more quickly, reducing the initial demand on the A/C system.
Increasing fuel economy
- Keep the engine properly tuned and operating in good condition.
- Follow the recommended scheduled maintenance intervals for the Mitsubishi Outlander.
- Maintain the tires at the specified inflation pressure.
Low tire pressure increases rolling resistance and tire wear, which can reduce fuel economy.
- Keep the wheels correctly aligned.
Improper wheel alignment can increase tire wear and rolling resistance, resulting in lower fuel efficiency.
- Use engine oil with the recommended viscosity to help maintain proper lubrication and efficient engine operation.
Was this page helpful?