Diagnosis and Repair Work Flow
Work Flow
OVERALL SEQUENCE

DETAILED FLOW
INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.
>>GO TO 2.
SELF-DIAGNOSIS WITH CONSULT
Perform “All DTC Reading” with CONSULT.
Check if the DTC is detected on the self-diagnosis results of following.
“ICC/ADAS 2”
“LASER/RADAR”
“LANE CAMERA”
Is any DTC detected?
YES>>Record or print self-diagnosis results and freeze frame data (FFD).GO TO 5.
NO>>GO TO 3.
ACTION TEST
Perform Following system action test to check the operation status. Refer to Work Procedure.
Check if any other malfunctions occur.
>>GO TO 4.
SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table.
>>GO TO 6.
TROUBLE DIAGNOSIS BY DTC
Erase self-diagnostic results.
Ignition switch OFF → ON.
Check the DTC in the self-diagnosis results.
Perform trouble diagnosis for the detected DTC following.
“ICC/ADAS 2”(Without ProPILOT Assist 2.1): Refer to DTC Index.
“ICC/ADAS 2”(With ProPILOT Assist 2.1): Refer to DTC Index.
“LASER/RADAR”: Refer to DTC Index
“LANE CAMERA”: Refer to DTC Index.
GO TO 6.
MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.
>>GO TO 7.
REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)
Erases self-diagnosis results.
Perform “All DTC Reading” again after repairing or replacing the specific items.
Check if any DTC is detected in self-diagnosis results of following.
“ICC/ADAS 2”
“LASER/RADAR”
“LANE CAMERA”
Is any DTC detected?
YES>>GO TO 5.
NO>>GO TO 8.
REPAIR CHECK (ACTION TEST)
Perform the action test. Check that the malfunction symptom is solved or no other symptoms occur. Refer to Work Procedure.
Is there a malfunction symptom?
YES>>GO TO 4.
NO>>INSPECTION END