Driver Controls

Door Mirror

~4min read

Exploded View

Door mirror cover Power folding motor Door mirror finisher
Side turn signal lamp Puddle lamp bracket (with puddle lamp) Puddle lamp (with puddle lamp)
Door mirror housing assembly Glass mirror Door mirror base cover
Door mirror base gasket Door mirror base assembly Side camera (with side camera)
Side camera bracket (with side camera) Harness clip Side camera cover (without side camera)
Side camera harness B (with side camera) Side camera harness A (with side camera) Puddle lamp cover (without puddle lamp)
Vinyl tape
: Pawl
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
, , , : Indicates that the part is connected at points with same symbol in actual vehicle.

Door Mirror Assembly

Removal and Installation

REMOVAL

Remove front door sash inner cover. Refer to Removal & Installation.

Disconnect door mirror assembly harness connectors and .

Remove harness clip.

: Clip

Remove door mirror assembly mounting nuts .

Disengage door mirror assembly fixing pawl , and then remove door mirror assembly.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Situations
OperationsReplace door mirror assembly & side cameraReplace door mirror assembly (side camera reused)Replace side camera (door mirror assembly reused)Remove door mirror assembly with camera
Parameter writing for camera 1 - 1 - Refer to Work Procedure
Camera image calibration 2 1 2 1 Refer to Work Procedure

Disassembly and Assembly

DISASSEMBLY

Remove door mirror assembly. Refer to Removal and Installation.

Remove door mirror cover. Refer to Removal and Installation.

Disconnect all terminals from harness connector .

Remove harness clip and vinyl tape .

Remove door mirror base gasket.

Disengage door mirror base cover fixing pawls, and then remove door mirror base cover.

: Pawl

Remove door mirror base assembly fixing screws , and then remove door mirror base assembly.

Remove door mirror finisher fixing screws .

Disengage door mirror finisher fixing pawls, and then remove door mirror finisher from door mirror housing assembly.

: Pawl

Remove side camera (with side camera) or side camera cover (without side camera). Refer to the follows.

  • Side camera: Removal and Installation.

  • Side camera cover: Remove side camera cover fixing pawls, and then remove side camera cover.

Remove side turn signal lamp. Refer to Removal & Installation.

Remove puddle lamp (with puddle lamp) or puddle lamp cover (without puddle lamp). Refer to the follows.

  • Puddle lamp: Removal and Installation.

  • Puddle lamp cover: Remove puddle lamp cover fixing pawls, and then remove puddle lamp cover.

Disconnect harness connector .

Remove power folding motor fixing screws , and then remove power folding motor.

: vehicle front

Remove harness from power folding motor.

Disconnect side camera harness A and side camera harness B (with side camera).

ASSEMBLY

Note the following items, and then assemble in the reverse order of disassembly.

Glass Mirror

Removal and Installation

REMOVAL

Place glass mirror upward.

Apply protective tapes (A) on the part to protect it from damage.

Insert remover tool (A) into the recess at between glass mirror and door mirror actuator, and then disengage glass mirror fixing pawls.

: Pawl

Disconnect BSW harness connector .

Disconnect auto anti-dazzling harness connector (if equipped).

Disconnect door mirror heater harness connectors (if equipped).

Remove glass mirror.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

Door Mirror Cover

Removal and Installation

REMOVAL

Remove glass mirror. Refer to Removal and Installation.

Apply protective tapes (A) on the part to protect it from damage.

Disengage door mirror cover fixing pawls from door mirror housing assembly .

: Pawl

Remove door mirror cover.

INSTALLATION

Note the following item, and then install in the reverse order of removal.