Transmission & Driveline

Front Wheel Hub and Knuckle

~3min read

Exploded View

Upper ball seat Steering knuckle Baffle
Splash guard Wheel hub and bearing assembly Disc rotor
Hub bolt Cotter pin Lower ball seat
: vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.

Removal and Installation

REMOVAL

Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.

Remove brake hose bracket. Refer to Removal and Installation.

Remove brake caliper assembly. Hang brake caliper assembly in a place where it will not interfere with work. Refer to FRONT BRAKE CALIPER ASSEMBLY : Removal & Installation.

Remove disc rotor.

Remove wheel sensor harness. Refer to Removal and Installation.

Remove steering outer socket. Refer to Removal and Installation.

Set suitable jack under lower link.

Remove shock absorber mounting bolt from lower link. Refer to Removal and Installation.

Remove wheel hub and bearing assembly, and then remove splash guard and baffle.

Separate upper link from steering knuckle, using the ball joint remover (commercial service tool), and remove upper link.

Remove lower link from steering knuckle.

Remove steering knuckle.

Remove hub bolts from wheel hub assembly, using the ball joint remover (commercial service tool) (A).

Perform inspection after removal. Refer to Inspection.

INSTALLATION

Note the following, and install in the reverse order of the removal.

Hub Bolts

Place a suitable washer as shown in the figure to install the hub bolts by using the tightening force of the nut .

Disc rotor

Inspection

INSPECTION AFTER REMOVAL

Check the following items, and replace the part if necessary.

Ball Joint Inspection

Check boots of upper link, lower link and steering outer socket ball joint for breakage, axial play, and swing torque:

  • Upper link: Refer to Inspection.

  • Lower link: Refer to Inspection.

  • Steering outer socket ball joint: Refer to Inspection.

INSPECTION AFTER INSTALLATION

Check runout of disc rotor, when replaced the disc rotor. Refer to Inspection and Adjustment.

Check wheel sensor harness for proper connection. Refer to Exploded View.

Check the wheel alignment. Refer to Inspection.

Adjust neutral position of steering angle sensor. Refer to Work Procedure.