Rear Propeller Shaft
Exploded View
REMOVAL

| Propeller shaft assembly |
| : vehicle front | |||||
DISASSEMBLY

| Snap ring | Journal bearing | Journal | |||
| Flange yoke | Propeller shaft (1st shaft) | Propeller shaft (2nd shaft) |
| : vehicle front | |||||
Removal and Installation
REMOVAL
Shift the transmission to the neutral position, and then release the parking brake.
Put matching mark
on rear propeller shaft flange yoke and transmission companion flange.

Put matching mark
on rear propeller shaft flange yoke and rear final drive companion flange.

Remove center bearing mounting bracket fixing nuts (
).

Remove propeller shaft assembly fixing bolts and nuts, and separate propeller shaft assembly from transmission companion flange and final drive companion flange.
Remove propeller shaft assembly.
Perform inspection after removal. Refer to Inspection.
INSTALLATION
Note the following, and install in the reverse order of removal.
For non-reusable parts, refer to Exploded View.
For each tightening torque, refer to Exploded View.
Align matching mark
to install propeller shaft flange yoke and rear final drive companion flange.
Align matching mark
to install propeller shaft flange yoke and transmission companion flange.
If propeller shaft or final drive has been replaced, connect them as follows:
- Install propeller shaft
while aligning matching mark
of propeller shaft with matching mark
of final drive
on the joint as close as possible.

- Install propeller shaft
Perform inspection after installation. Refer to Inspection.
Disassembly and Assembly
DISASSEMBLY
Put a matching mark between propeller shaft and flange yoke as shown.

Remove snap rings
.

Lightly tap bottom of yoke using a copper hammer and remove journal bearing.

Remove grease nipple.
ASSEMBLY
Install journal bearing to journal.
Install bearing
using a vise.
Install journal to propeller shaft so that grease nipple
on journal portion is in the same direction.
Install snap rings
.

Check that the journal moves smoothly and is below the joint flex torque specification.

| Joint flex torque | : Refer to Journal. |
Check the journal axial play. Refer to Inspection.
Inspection
INSPECTION AFTER REMOVAL
Appearance
Check propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly.
Propeller Shaft Runout
Check propeller shaft runout at several points with a dial indicator. If runout exceeds specifications, replace propeller shaft assembly.

| Propeller shaft runout | : Refer to Propeller Shaft Tube. |
Journal Axial Play
As shown in the figure, while fixing yoke on one side, check axial play of joint. If the journal axial play exceeds the specification, repair or replace the journal parts.

| Journal axial play | : Refer to Journal. |
Joint Flex Torque
Check that the journal moves smoothly and is below the joint flex torque specification. If the joint flex torque exceeds the specification, repair or replace the journal parts.

| Joint flex torque | : Refer to Journal. |
Center Bearing
Check center bearing for noise and damage. If malfunction is detected, replace propeller shaft assembly.