Transmission & Driveline

Rear Propeller Shaft

~4min read
03060901201509872N·mlb·ft
Tightening torque found on this page

Exploded View

REMOVAL

Propeller shaft assembly
: vehicle front
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.

DISASSEMBLY

Snap ring Journal bearing Journal
Flange yoke Propeller shaft tube
: vehicle front
: Always replace after every disassembly.
: Select with proper thickness.
: Apply multi-purpose grease.

Removal and Installation

REMOVAL

Shift the transmission to the neutral position, and then release the parking brake.

Put matching mark on rear propeller shaft flange yoke and final drive companion flange.

Put matching mark on rear propeller shaft flange yoke and transfer companion flange.

Remove propeller shaft assembly fixing bolts and nuts.

Remove propeller shaft assembly from vehicle.

Perform inspection after removal. Refer to Inspection.

INSTALLATION

Note the following, and install in the reverse order of removal.

  • For non-reusable parts, refer to Exploded View.

  • For each tightening torque, refer to Exploded View.

  • Align matching marks to install propeller shaft flange yoke and transfer companion flange.

  • Align matching marks to install propeller shaft flange yoke and final drive companion flange.

  • If propeller shaft assembly or final drive assembly has been replaced, connect them as follows:

    • Install propeller shaft while aligning matching mark of propeller shaft with matching mark of final drive on the joint as close as possible.

  • Perform inspection after installation. Refer to Inspection.

Disassembly and Assembly

DISASSEMBLY

Put a matching mark between propeller shaft and flange yoke as shown.

Remove snap rings .

Lightly tap bottom of yoke using a copper hammer and remove journal bearing.

ASSEMBLY

Install journal bearing to journal.

  • Install bearing using a vise.

Measure journal axial play. If necessary, select the appropriate snap ring.While pushing to 98 N·m, check the clearance between snap ring and needle bearing .

Journal axial play : Refer to Journal.
If journal axial play is outside the specification, use a thicker/thinner snap ring to adjust.

Install snap rings .

Check that the journal moves smoothly and is below the joint flex torque specification.

Joint flex torque : Refer to Journal.

Check the journal axial play. Refer to Inspection.

Inspection

INSPECTION AFTER REMOVAL

Appearance

Check propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly.

Propeller Shaft Runout

Check propeller shaft runout at several points with a dial indicator. If runout exceeds specifications, replace propeller shaft assembly.

Propeller shaft runout : Refer to Propeller Shaft Tube.
  • Propeller shaft runout measuring point (Point “”).

    : vehicle front
    Dimension
    A : 130 – 150 mm (5.12 – 5.91 in)
    B : 150 – 180 mm (5.91 – 7.09 in)
    C : 734.0 mm (28.90 in)

Journal Axial Play

As shown in the figure, while fixing yoke on one side, check axial play of joint. If the journal axial play exceeds the specification, repair or replace the journal parts.

Journal axial play : Refer to Journal.

Joint Flex Torque

Check that the journal moves smoothly and is below the joint flex torque specification. If the joint flex torque exceeds the specification, repair or replace the journal parts.

Joint flex torque : Refer to Journal.

INSPECTION AFTER INSTALLATION