Heater & Air Conditioning Control System Type 1
A/C auto AMP.
In this manual: Heater & Air Conditioning Control System Type 1
~1min read
Reference Value
CONSULT-III DATA MONITOR REFERENCE VALUES

*: “DUTY” is displayed, but voltage is indicated. Or unit is not displayed but unit is (V).
TERMINAL LAYOUT

PHYSICAL VALUES


Fail-safe
FAIL-SAFE FUNCTION
If a communication error exists between the A/C auto amp. and multi display unit for 2 seconds or longer, air conditioning is controlled under the following conditions:
A/C display : OFF
Set temperature : Setting before communication error occurs Air outlet : AUTO
Air flow : AUTO
Air inlet : FRE (Fresh air intake) A/C switch : ON
DTC Index

*: Perform self-diagnosis under sunshine. When performing indoors, aim a light (more than 60 W) at sunload sensor, otherwise self-diagnosis indicates even though the sunload sensor is functioning normally.
Was this page helpful?