Door & Lock type 3
Back door opener actuator
In this manual: Door & Lock type 3
~1min read
Diagnosis Procedure 1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect back door opener assembly connector.



3. Check voltage between back door opener assembly harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK BACK DOOR OPENER ACTUATOR CIRCUIT 1. Disconnect BCM connector.2. Check continuity between BCM harness connector and back door opener assembly harness connector.

3. Check continuity between BCM harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK BACK DOOR OPENER ACTUATOR GROUND CIRCUITCheck continuity between back door opener assembly harness connector and ground.

Is the inspection normal? YES >> Replace back door opener assembly.
NO >> Repair or replace harness.
Was this page helpful?