Basic inspection
DETAILED FLOW
1.INTERVIEW FROM THE CUSTOMERClarify customer complaints before inspection. First of all, perform an interview utilizing STC-17, "Diagnostic Work Sheet" and reproduce symptoms as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving vehicle with customer, if necessary.
CAUTION:Customers are not professional. Never guess easily like “maybe the customer means that...,” or “maybe the customer mentions this symptom”.
>> GO TO 2.
2.CHECK SYMPTOMReproduce the symptom that is indicated by the customer, based on the information from the customer obtained by interview. Also check that the symptom is not caused by protection function. Refer to STC-13, "Protection Function".
CAUTION:When the symptom is caused by normal operation, fully inspect each portion and obtain the understanding of customer that the symptom is not caused by a malfunction.
>> GO TO 3.
3.PERFORM SELF-DIAGNOSIS
With CONSULT-III
Perform self-diagnosis for “EPS”.
Is any DTC detected? YES >> Record or print self-diagnosis results. GO TO 4.
NO >> GO TO 6.
With CONSULT-III
1. Erase self-diagnostic results for “EPS”.
2. Perform DTC confirmation procedures for the error detected system.
NOTE:
If some DTCs are detected at the same time, determine the order for performing the diagnosis based on STC- 13, "DTC Inspection Priority Chart".
Is any DTC detected? YES >> GO TO 5.
NO >> Check harness and connectors based on the information obtained by interview. Refer to GI-42, "Intermittent Incident".
5.REPAIR OR REPLACE ERROR-DETECTED PARTS • Repair or replace error-detected parts. • Reconnect part or connector after repairing or replacing.• When DTC is detected, erase self-diagnostic results for “EPS”.
>> GO TO 7.
6.IDENTIFY ERROR-DETECTED SYSTEM BY SYMPTOM DIAGNOSISEstimate error-detected system based on symptom diagnosis and perform inspection.
Can the error-detected system be identified?
NO >> Check harness and connectors based on the information obtained by interview. Refer to GI-42, "Intermittent Incident".
7.FINAL CHECK
With CONSULT-III
1. Check the reference value for EPS control unit.
2. Recheck the symptom and check that symptom is not reproduced on the same conditions.
Is the symptom reproduced? YES >> GO TO 3.
NO >> INSPECTION END
Diagnostic Work Sheet Description• In general, customers have their own criteria for a problem. Therefore, it is important to understand the symptom and status well enough by asking the customer about his/her concerns carefully. To systemize all the information for the diagnosis, prepare the interview sheet referring to the interview points.
• In some cases, multiple conditions that appear simultaneously may cause a DTC to be detected.
Interview sheet sample

