Basic inspection
OVERALL SEQUENCE

DETAILED FLOW
1.INTERVIEW THE CUSTOMER FOR THE SYMPTOMInterview the customer for the symptom (the condition and the environment when the incident/malfunction occurs).
>> GO TO 2.
2.CHECK SYMPTOMCheck the symptom from the customer information.
>> GO TO 3.
3.CHECK WARNING LAMP OPERATIONCheck air bag warning lamp operation in the user mode. Refer to SRC-12, "On Board Diagnosis Function".
Are any malfunction detected? YES >> GO TO 5.
NO >> GO TO 4.
4.CHECK LOW VOLTAGECheck low voltage with CONSULT-III (Special function). Refer to SRC-16, "CONSULT-III Function".
Are any malfunction detected? YES >> GO TO 9.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
5.CHECK SELF DIAGNOSTIC RESULTSCheck self diagnostic result with CONSULT-III or diagnosis mode.
If it is impossible to switch to diagnosis mode, follow the same procedure that DTC is not detected.
NOTE:
Perform the following procedure if DTC is detected.
• Check related service bulletins for information.
Is DTC detected? YES >> GO TO 6.
NO >> GO TO 7.
6.PERFORM DTC CONFIRMATION PROCEDUREPerform DTC CONFIRMATION PROCEDURE for the DTC.
>> GO TO 8.
7.PERFORM DIAGNOSIS ACCORDING TO WARNING LAMP OPERATION 1. Check air bag warning lamp operation in the user mode. Refer to SRC-12, "On Board Diagnosis Function".2. Perform Diagnosis Procedure for the air bag warning lamp operation. Refer to SRC-12, "On Board Diagnosis Function" (USER MODE).
>> GO TO 9.
8.DETECT MALFUNCTIONING PART BY DIAGNOSTIC PROCEDUREInspect according to Diagnostic Procedure of the DTC.
>> GO TO 9.
9.REPAIR OR REPLACE THE MALFUNCTION PARTRepair or replace the malfunctioning part.
>> GO TO 10.
10.FINAL CHECKCheck self diagnostic result and air bag warning lamp operation in the user mode.
Is the malfunction repaired? YES >> INSPECTION END
NO >> GO TO 2.