Rear Suspension 2WD
Coil spring
In this manual: Rear Suspension 2WD
~1min read
Exploded View

1. Upper rubber seat 2. Coil spring
3. Lower rubber seat
4. Rear suspension beam
Removal and Installation
REMOVAL
1. Remove tires. Refer to WT-7, "Removal and Installation".2. Set jack under rear suspension beam.
CAUTION:• Never damage the suspension beam with a jack.
• Check the stable condition when using a ja
ck.
3. Remove rear shock absorber mounting bolts (lower side). Refer to RSU-8, "Exploded View".4. Slowly lower jack, then remove upper rubber seat, coil spring and lower rubber seat from rear suspension beam.
CAUTION:Operate while checking that jack supporting status is stable.
5. Perform inspection after removal. Refer to RSU-12, "Inspection".

INSTALLATION
Note the following, and install in the reverse order of removal.
• Install lower rubber seat with its protrusion (A) on the lower area aligned with the hole of rear suspension beam. • Securely install coil spring with the lower end (B) of the major diameter aligned with the steps of lower rubber seat.• Perform inspection after installation. Refer to RSU-12, "Inspection".

Inspection
INSPECTION AFTER REMOVAL
Check lubber seat and coil spring for deformation, crack, and damage. Replace it if necessary.
INSPECTION AFTER INSTALLATION
Check wheel alignment. Refer to RSU-6, "Inspection".
Was this page helpful?