Compressor dose dot operate
Description
SYMPTOM Compressor dose not operate.
Diagnosis Procedure
NOTE:• Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. • Check that refrigerant is enclosed in cooler cycle normally. If the refrigerant amount is shortage from proper amount, perform the inspection of refrigerant leakage 1.CHECK A/C INDICATOR 1. Turn ignition switch ON. 2. Operate blower motor.
3. Check that A/C indicator is turned ON/OFF when operating A/C switch.
Is the inspection result normal? YES >> GO TO 2.
NO >> GO TO 5.
2.CHECK MAGNET CLUTCH OPERATIONCheck magnet clutch. Refer to HAC-232, "Component Function Check".
Does it operate normally? YES >> GO TO 3.
NO >> Repair or replace malfunctioning parts.
3.CHECK REFRIGERANT PRESSURE SENSORCheck refrigerant pressure sensor. Refer to EC-423, "Component Function Check".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace malfunctioning parts.
4.CHECK BCM OUTPUT SIGNAL
With CONSULT-III
1. Select “DATA MONITOR” mode of “ECM” using CONSULT-III.
2. Select “AIR COND SIG” and “HEATER FAN SW”, and check status under the following conditions.

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (with Intelligent Key) or PCS-63, "Removal and Installation" (without Intelligent Key).
NO >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key) or BCS-161, "Removal and Installation" (without Intelligent Key).
5.CHECK A/C SWITCHCheck A/C switch. Refer to HAC-220, "Component Function Check".
Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace the malfunctioning parts.
6.CHECK BLOWER FAN ON SIGNALCheck blower fan ON signal. Refer to HAC-222, "Component Function Check".
Is the inspection result normal? YES >> GO TO 7.
NO >> Repair or replace the malfunctioning parts 7.CHECK THERMO CONTROL AMP.Check thermo control amp. Refer to HAC-224, "Component Function Check".
Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key) or BCS-161, "Removal and Installation" (without Intelligent Key).
NO >> Repair or replace the malfunctioning parts