Diagnosis system [ABS actuator and electric unit (control unit)]
APPLICATION ITEMS
CONSULT-III can display each diagnostic item using the diagnostic test modes as follows.

*1: The following diagnosis information is erased by erasing.
• DTC
• Freeze frame data (FFD) *2: Although “Function Test” is selectable, do not use its.
ECU IDENTIFICATION
ABS actuator and electric unit (control unit) part number can be read.
SELF DIAGNOSTIC RESULT
Refer to BRC-142, "DTC Index".
When “CRNT” is displayed on self-diagnosis result • The system is presently malfunctioning.
When “PAST” is displayed on self-diagnosis result • System malfunction in the past is detected, but the system is presently normal.
Freeze frame data (FFD)
When DTC is detected, a vehicle state shown below is recorded and displayed on CONSULT-III.

DATA MONITOR



*1: Refer to BRC-105, "System Description" for ON/OFF conditions of each warning lamp
.
*2: Models with CVT
ACTIVE TEST
The active test is used to determine and identify details of a malfunction, based on self-diagnosis test result sand data obtained in the DATA MONITOR. In response to instructions from CONSULT-III, instead of those from ABS actuator and electric unit (control unit) on the vehicle, a drive signal is sent to the actuator to check its operation.
CAUTION:• Never perform ACTIVE TEST while driving the vehicle. • Always bleed air from brake system before ACTIVE TEST.
• Never perform ACTIVE TEST when system is malfunctioning.
NOTE:
• When active test is performed while depressing the pedal, the pedal depressing stroke may change. This is not a malfunction. • “TEST IS STOPPED” is displayed approx. 10 seconds after operation start. • When performing active test again after “TEST IS STOPPED” is displayed, select “BACK”.• ABS warning lamp and brake warning lamp may turn ON during active test. This is not a malfunction.
ABS IN Valve and ABS OUT Valve When “Up”, “Keep” or “Down” is selected on display screen, the following items are displayed when system is normal.

*: Immediately after being selected, status is “On”. Status changes to “Off” after approx. 2 seconds.
ABS IN Valve (ACT) and ABS OUT Valve (ACT) When “Up”, “ACT KEEP” or “ACT UP” is selected on display screen, the following items are displayed when system is normal.

*: Immediately after being selected, status is “On”. Status changes to “Off” after approx. 2 seconds.
ABS Motor
When “On” or “Off” is selected on display screen, the following items are displayed when system is normal.
