Engine Control System MR16DDT
ECM
In this manual: Engine Control System MR16DDT
~1min read
Removal and Installation
Must be perform additional service when replacing ECM. Refer toEC-133, "Work Procedure".
REMOVAL
1. Remove fusible link bracket. Keep a service area. 2. Disconnect ECM harness connectors. Refer to PG-4, "Harness Connector".3. Remove ECM mounting nuts, and then remove ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:Must be perform additional service when replacing ECM. Refer toEC-133, "Work Procedure".
Was this page helpful?