Fuel system HR16DE
General Precautions
In this manual: Fuel system HR16DE
~1min read
• Put a “CAUTION: FLAMMABLE” sign in the workshop. • Be sure to work in a well ventilated area and furnish workshop with a CO2 fire extinguisher.
• Use gasoline required by the regulations for octane number. Refer to GI-35, "Fuel". • Before removing fuel line parts, perform out the following procedures: - Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in safe area. - Release fuel pressure from the fuel lines. Refer to EC-551, "Work Procedure".
• Never smoke while servicing fuel system. Keep open flames and sparks away from the work area.
CAUTION:• Use gasoline required by the regulations for octane number. Refer to GI-35, "Fuel". • Before removing fuel line parts, perform out the following procedures: - Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in safe area. - Release fuel pressure from the fuel lines. Refer to EC-551, "Work Procedure".
- Disconnect the battery cable from the negative terminal.
• Always replace O-ring and clamps with new ones. • Never kink or twist tubes when they are being installed. • Never tighten hose clamps excessively to avoid damaging hoses. • After installing tubes, check there is no fuel leakage at connections in the following steps. - Apply fuel pressure to fuel lines with turning ignition switch “ON” (with engine stopped). Then check for fuel leakage at connections.- Start engine and rev it up and check for fuel leakage at connections.
• Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the “MI” may come on. • For servicing “EVAPORATIVE EMISSION SYSTEM” parts, refer to EC-480, "EVAPORATIVE EMISSION SYSTEM : System Diagram".Was this page helpful?