Engine Lubrication System MR16DDT
Inspection
In this manual: Engine Lubrication System MR16DDT
~1min read
INSPECTION AFTER REMOVAL
Oil Cooler
Check oil cooler for cracks. Check oil cooler for clogging by blowing through engine coolant inlet. If necessary, replace oil cooler assembly.
INSPECTION AFTER INSTALLATION
1. Check the engine oil level and the engine coolant level and add engine oil and engine coolant. Refer to LU-8, "Inspection" and CO-11, "Inspection". 2. Start the engine, and check that there is no leakage of engine oil or engine coolant. 3. Stop the engine and wait for 10 minutes.4. Check the engine oil level and the engine coolant level again. Refer to LU-8, "Inspection" and CO-11, "Inspection".
Was this page helpful?