Technical and consumer information

Installing front license plate

~1min read
Use the following steps to mount the license plate:

Use the following steps to mount the license plate:

Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag.

• License plate bracket • J-nut •  Screw   2 2
• Screw • Screw grommet   2 2
• Screw grommet 1. Park the vehicle on flat, level ground. 2


1. Park the vehicle on flat, level ground.

2. Locate the center positionA as illustrated.

Make sure the side end surface of the license plate bracket is aligned with the bumperB . 3. Mark the center of the holesC with a felttip pen. 4. Carefully drill the two pilot holes using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the bumper fascia.) 5. Insert grommets into the hole on the fascia. 6. Insert a flat-blade screwdriver into the grommet hole to add a 908 turn onto the partD . 7. Insert a J-nut into the license plate bracket before placing the license plate bracket on the fascia. 8. Install the license plate bracket with the screws.

9. Install the license plate with bolts that are not longer than 0.55 in (14 mm).