Maintenance and do-it-yourself
Keyfob
In this manual: Maintenance and do-it-yourself
~1min read
Replace the battery in the keyfob as follows:
1. Remove the screw. 2. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.3. Replace the battery with a new one.
Recommended battery:
CR1620 or equivalent
• Do not touch the internal circuit and electric terminals as doing so could cause a malfunction. • Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity.• Make sure that the + side faces the bottom of the case.
4. Close the lid securely and install the screw.5. Operate the buttons to check its operation.
See a NISSAN dealer if you need any assistance for replacement.
FCC Notice: For USA:This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
For Canada: This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Was this page helpful?