Parking Brake System
Parking brake shoe
In this manual: Parking Brake System
~1min read
Adjustment 1. Adjust parking brake lever stroke. Refer to PB-2, "Inspection and Adjustment".
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
If it is out of the specification, adjust again. Refer to PB-2, "Inspection and Adjustment".
2. Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions: • Drive forward
• Vehicle speed: Approx. 43 km/h set (constant and forward) • Parking brake operating force: 125 N (12.8 kg, 28.1 lb) set contact • Time: Approx. 8 sec.
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
3. After the break-in procedure, check parking brake lever stroke of parking brake.
CAUTION:If it is out of the specification, adjust again. Refer to PB-2, "Inspection and Adjustment".
Was this page helpful?