Parking brake shoe
Exploded View

1. Anti-rattle pin
2. Back plate
3. Toggle lever
4. Parking brake shoe
5. Brake strut
6. Return spring
7. Spring
8. Adjuster
: Apply PBC (Poly Butyl
Cuprysil) grease or silicone-based grease.
Removal and Installation
REMOVAL
WARNING:Clean any dust from the parking brake shoes and back plates with a vacuum dust collector. Never blow with compressed air. 1. Remove rear tires.
2. Remove disc rotor.
• 2WD: Refer to RAX-5, "Removal and Installation".• 4WD: Refer to RAX-14, "Removal and Installation".
CAUTION:Parking brake completely in the released position.
3. Remove return spring (1) of the upper side.

4. Remove return spring (1) of the lower side.

5. Remove spring (1).
CAUTION:Never drop the removed p
arts.
6. Remove parking brake shoes, adjuster, brake strut and toggle lever.
CAUTION:• The parking brake shoes for the front wheels are made of different materials from those for the rear wheels. Never misidentify them when removing.
• Never drop the removed parts.

7. Press the rear cable spring (1) against spring tension to remove rear cable (3) from the clamp (A) of toggle lever (2).
CAUTION:Never bend rear cable
.
8. For the removal of back plate.
• 2WD: Refer to RAX-5, "Removal and Installation".• 4WD: Refer to RAX-14, "Removal and Installation".

INSTALLATION
Note the following, install in the reverse order of removal.
• Apply PBC (Poly Butyl Cuprysil) grease or silicone-based grease to the back plate and brake shoe.
CAUTION:The parking brake shoes for the front wheels are made of different materials from those for the rear wheels. Never misidentify them when removing and replacing.
• Assemble adjusters so that threaded part is expanded when rotating it in the direction shown by arrow.
A : For right side brake B : For left side brake
: Vehicle front
: Adjuster expands
• Shorten adjuster by rotating it.
• When disassembling apply PBC (Poly Butyl Cuprysil) grease or silicone- based grease to threads.

• Check that the component parts of the parking brake shoe are properly installed.
• Check brake shoe sliding surface and drum inner surface for grease. Wipe it off if it adhere on the surfaces.

Inspection and Adjustment
INSPECTION AFTER REMOVAL
Lining Thickness Inspection • Check thickness (A) of lining.
A : Refer to PB-11, "Parking Drum Brake".

Drum Inner Diameter Inspection • Check inner diameter (B) of drum.
B : Refer to PB-11, "Parking Drum Brake".

Other Inspections
Check the following items, and replace the parts if necessary.
• Visually check inside of the drum for excessive wear, cracks, and damage with a pair of vernier calipers.
ADJUSTMENT AFTER INSTALLATION
1. Adjust the parking brake lever stroke. Refer to PB-2, "Inspection and Adjustment".2. Rotate the disc rotor to check that there is no drag. Install the plug. If any drag is found, follow the procedure described below.
a. Adjust parking brake stroke again.b. Check rear disc brake.
• LHD: Refer to BR-68, "BRAKE CALIPER ASSEMBLY : Inspection".• RHD: Refer to BR-134, "BRAKE CALIPER ASSEMBLY : Inspection".
3. Adjust the parking brake shoe. Refer to PB-3, "Adjustment".