In this manual: Driveline rear propeller Shaft: 3Fφ16-ETJ75
~1min read
REAR PROPELLER SHAFTInspection
APPEARANCE AND NOISE
• Check the propeller shaft tube surface for dents or cracks. If damaged, replace propeller shaft assembly.
• If center bearing is noisy or damaged, replace propeller shaft assembly.
VIBRATION
If vibration is present at high speed, inspect propeller shaft runout first.
1. With a dial indicator, measure propeller shaft runout at runout measuring points by rotating final drive companion flange with hands.
Propeller shaft runout : Refer to DLN-125, "Propeller Shaft Runout".
• Propeller shaft runout measuring point (Point “ ”)
: Front
Dimension A: 542 mm (21.34 in) B: 516.5 mm (20.33 in)
2. If runout still exceeds specifications, separate propeller shaft at final drive companion flange or transfer companion flange; then change the phase between companion flange and propeller shaft by the one bolt hole at a time and install propeller shaft. 3. Check runout again. If runout still exceeds specifications, replace propeller shaft assembly.