Periodic maintenance
GEAR OIL
Inspection
OIL LEAKAGE
Make sure that gear oil is not leaking from transaxle or around it.
OIL LEVEL
1. Remove filler plug (1) and gasket from transaxle case.2. Check the oil level from filler plug mounting hole as shown in the figure.
CAUTION:Never start engine while checking oil level.
3. Set a gasket on filler plug and then install it to transaxle case.
CAUTION:Never reuse gasket.
4. Tighten filler plug to the specified torque. Refer to TM-88, "Exploded View".

Draining 1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil.
3. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool].
CAUTION:Never reuse gasket.
4. Tighten drain plug to the specified torque. Refer to TM-88, "Exploded View".

Refilling 1. Remove filler plug (1) and gasket from transaxle case.
2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure.
Oil grade and viscosity : Refer to MA-13, "Fluids and Lubricants".Oil capacity : Refer to TM-123, "General Specifications".

3. After refilling gear oil, check the oil level. Refer to TM-75, "Inspection".
4. Set a gasket on filler plug and then install it to transaxle case.
CAUTION:Never reuse gasket.
5. Tighten filler plug to the specified torque. Refer to TM-88, "Exploded View".