Accelerator control system
Removal and Installation
In this manual: Accelerator control system
~1min read
REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.2. Loosen mounting bolts, and remove accelerator pedal assembly.
CAUTION:• Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly. • Avoid impact from dropping etc. during handling.
• Be careful to keep accelerator pedal assembly away from water
.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Insert the locating pin while inserting the locating hook in to the break pedal bracket. Tighten mounting bolts to accelerator pedal assembly.
CAUTION:Never squeeze the locating hook into the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.
Was this page helpful?