Driveline transfer: TY21B
Writing unit parameter
In this manual: Driveline transfer: TY21B
~1min read
Description
Perform writing unit parameter of electric controlled coupling after replacing 4WD control module, rear final drive assembly or electric controlled coupling. Refer to DLN-39, "Work Procedure".
Work Procedure
1.WRITE UNIT PARAMETERWith CONSULT-III
1. Confirm the unit parameter (A) of electric controlled coupling (LH) and (B) of electric controlled coupling (RH).
NOTE:• This illustration is sample.
• For the illustration, the unit parameters are following.
Right side: 3B4D66BBE318 Left side: 3B4D66BBE32B
2. Turn the ignition switch OFF to ON. 3. Select “UNIT CHARACTERISTICS WRITE” of CONSULT-III “WORK SUPPORT” for “ALL MODE AWD/4WD”. 4. Input unit parameters. 5. Select “Start”.6. Check that “UNIT CHARACTERISTICS WRITE COMPLETED” is displayed.

>> WORK END
Was this page helpful?