Electrical & Power Control

Charging System :: Removal and Installation. Generator

~1min read
02040608010064.748N·mlb·ft
Tightening torque found on this page
Exploded View
1. Generator bracket 2. Generator 3. "B" terminal nut
Front
Removal and Installation

REMOVAL

Remove radiator assembly. Refer to Removal and Installation.

Remove cooling fan assembly. Refer to Removal and Installation.

Remove drive belt auto-tensioner assembly. Refer to Removal and Installation of Drive Belt Auto-tensioner.

Disconnect the harness connectors from the generator.

Remove generator bracket.

Remove generator bolts and nut using power tools.

Slide the generator out and remove.

INSTALLATION

Installation is in the reverse order of removal.

  • Temporarily tighten bolts and nut then tighten nut and bolts in the specified numerical order.

    Nut 1 65 N·m
    Bolt 2 28 N·m
    Bolt 3 25 N·m

  • Install generator and check tension of belt. Refer to Checking Drive Belt.

Inspection

Perform the following.

Make sure that generator pulley does not rattle.

Make sure that generator pulley nut is tight.