Driver Controls

Defogger :: Basic Inspection. Diagnosis and Repair Work Flow

6steps
~36min
2/5difficulty
Done 0 of 6
Work Flow

OVERALL SEQUENCE

DETAILED FLOW

GET INFORMATION FOR SYMPTOM

Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).

>>

GO TO 2.

CHECK DTC

CONSULT

  1. Check DTC.

  2. Perform the following procedure if DTC is displayed:

    • Record DTC and freeze frame data. (Print them out.)

    • Erase DTC.

    • Study the relationship between the cause detected by DTC and the symptom described by the customer.

  3. Check related service bulletins for information.

Is any symptom described and any DTC detected?

Symptom is described, DTC is displayed>>

GO TO 3.

Symptom is described, DTC is not displayed>>

GO TO 4.

Symptom is not described, DTC is displayed>>

GO TO 5.

CONFIRM THE SYMPTOM

CONSULT

Confirm the symptom described by the customer.

Select "Data Monitor" mode of "BCM(REAR DEFOGGER)" and check real-time diagnosis results.

Verify relation between the symptom and the condition when the symptom is detected.

>>

GO TO 5.

CONFIRM THE SYMPTOM

CONSULT

Confirm the symptom described by the customer.

Select "Data Monitor" mode of "BCM(REAR DEFOGGER)" and check real-time diagnosis results.

Verify relation between the symptom and the condition when the symptom is detected.

>>

GO TO 6.

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

Perform DTC Confirmation Procedure for the displayed DTC, and then check that DTC is detected again.

At this time, always connect CONSULT to the Nissan Murano vehicle, and check diagnostic results in real time.

If two or more DTCs are detected, refer to DTC Inspection Priority Chart and determine trouble diagnosis order.

Is DTC detected?

YES>>

GO TO 6.

NO>>

Refer to Intermittent Incident.

DETECT MALFUNCTIONING SYSTEM BY SYMPTOM DIAGNOSIS

Detect malfunctioning system according to System Description based on the confirmed symptom in step 4, and determine the trouble diagnosis order based on possible causes and symptom.

>>

GO TO 7.

DETECT MALFUNCTIONING PART BY DIAGNOSTIC PROCEDURE

CONSULT

Inspect according to Diagnostic Procedure of the system.

Is malfunctioning part detected?

YES>>

GO TO 8.

NO>>

Check voltage of related BCM terminals.

REPAIR OR REPLACE THE MALFUNCTIONING PART

CONSULT

  1. Repair or replace the malfunctioning part.

  2. Reconnect parts or connectors disconnected during Diagnostic Procedure after repair and replacement.

  3. Check DTC. If DTC is displayed, erase it.

>>

GO TO 9.

FINAL CHECK

When DTC was detected in step 2, perform DTC Confirmation Procedure or Component Function Check again, and then check that the malfunction has been repaired.

When symptom was described by the customer, refer to confirmed symptom in step 3 or 4, and check that the symptom is not detected.

Does the symptom reappear?

YES (DTC is detected)>>

GO TO 7.

YES (Symptom remains)>>

GO TO 6.

NO>>

Inspection End.